Page 1 of 1
Mission start issue
Posted: Fri Aug 03, 2012 8:03 am
by Rattler-1985
When I play as a mercenary commander the game closes after I press start mission. Is there any way to correct this?
Re: Mission start issue
Posted: Fri Aug 03, 2012 12:22 pm
by Sir MMPD Radick
details please?
Forum rules
Please provide the following when making a support request.
1. OS & Service Pack.
2. Version of Mercenaries that is being used.
3. If you are using 95 Mercs, please provide what method you are using to run it? (ie. Kontza's or Slugs Hook)
4a. If you are using DOS have you read the install guide?
4b. If you are using 95 have you watched the 95 install video?
5. What were the steps that you did after the initial installation? (if applicable)
But I will say if your not using the DOS version... probably you should.
Re: Mission start issue
Posted: Sun Aug 05, 2012 6:23 am
by Rattler-1985
Amd athlon 64 x2 dual core processor 3800+, MMX, 3dnow (2cpus)
1024 MB RAM
ATR Radeon HD 5450
Sound blaster audigy
Re: Mission start issue
Posted: Mon Aug 06, 2012 5:16 pm
by Sir MMPD Radick
Again.. version of mercs you are attempting to use please?
Re: Mission start issue
Posted: Mon Aug 06, 2012 6:40 pm
by Rattler-1985
On the left side of the CD it says:
CD2-3580-101-U3
1.05
I am not using DOS-box. I installed using mechvm. The file I use to run the game is MERCSWIN.EXE.
The regular campaign with finances disabled works fine.
Re: Mission start issue
Posted: Mon Aug 06, 2012 9:22 pm
by Sir MMPD Radick
the 95 version is unstable.. DOS is about all you can do if its not working.
If ya want the 95 version i'd just be happy with what works... its always a tossup if it works or not.