After about an hour of searching through the forums and a headache I figured I'd just ask this.
I'm loving re-living Mechwarrior via the MechVM. However, my current joystick (Logitech Extreme 3d Pro) seems to only have Y-X axis movement. Everyone knows a good mechwarrior needs to be able to twist his torso . So, what would one have to do to set this up for my z axis on the joystick? Thanks
Joystick Trouble
Forum rules
Please provide the following when making a support request.
1. OS & Service Pack.
2. Version of Mercenaries that is being used.
3. If you are using 95 Mercs, please provide what method you are using to run it? (ie. Kontza's or Slugs Hook)
4a. If you are using DOS have you read the install guide?
4b. If you are using 95 have you watched the 95 install video?
5. What were the steps that you did after the initial installation? (if applicable)
Please provide the following when making a support request.
1. OS & Service Pack.
2. Version of Mercenaries that is being used.
3. If you are using 95 Mercs, please provide what method you are using to run it? (ie. Kontza's or Slugs Hook)
4a. If you are using DOS have you read the install guide?
4b. If you are using 95 have you watched the 95 install video?
5. What were the steps that you did after the initial installation? (if applicable)
- ThePorthos
- I.S. Mech Washer
- Posts: 21
- Joined: Mon Feb 22, 2010 10:32 pm
- Contact:
- ThePorthos
- I.S. Mech Washer
- Posts: 21
- Joined: Mon Feb 22, 2010 10:32 pm
- Contact:
Re: Joystick Trouble
Nevermind I figured it out and now feel stupid.
- Hadakajime
- House Steiner Private
- Posts: 50
- Joined: Mon Feb 01, 2010 6:36 pm
Re: Joystick Trouble
post up your solution so other people can use it too.
- ThePorthos
- I.S. Mech Washer
- Posts: 21
- Joined: Mon Feb 22, 2010 10:32 pm
- Contact:
Re: Joystick Trouble
Its easy, just go into control options and go to custom configuration, I was hitting joystick control and it was kicking me to control panel. For anyone who has problems with the throttle being reversed, its as easy as clicking the -/+ next to the command binding and it will turn it into +/- (or vice versa)